XT2.5 20cm stepper motor cable 4pin-6pin 3D printing - connection cable for stepper motors used...HobbyStore
KP08 Block Housing Unit
The miniature pillow block bearing KP-08-ST is suitable for particularly small shaft diameters and high radial loads. The housing is made of zinc die-cast and it is very sturdy.
- Width: 13mm
- Length: 55mm
- Height: 29mm
- Mounting hole size: 4mm
- Bore size: 8mm
- Pitch: 42mm
- Bearing insert can compensate for low static misalignment
- Two-piece sealing system: with sheet steel washer reinforced rubber seal inside; outside additionally with upstream slinger made of sheet steel for high mechanical protection against foreign matter
- Lubricated for life; under normal operating conditions relubrication is not required.